|
Post by Glen on May 25, 2006 16:10:47 GMT -5
One of my rear side chain plates is about to break at the top bolt hole. I removed this plate and want to get to get more made. They all appear to be the same size, but I could not get an exact drill measurement on the others with out taking them off.. Were all 6 side plates made to the same hole pattern and deminsions as the one I took off? If I take this one to my machinest and got all 6 made, should the bolt holes line up on the others? Or any suggestions from someone who has been there would be appreciated.
Thanks Glen
|
|
|
Post by roscoe1 on May 25, 2006 21:26:17 GMT -5
The holes are the same for all chainplates. Roscoe
|
|
|
Post by Glen on May 26, 2006 10:05:25 GMT -5
Thank you, Roscoe.
|
|