|
|
Post by msparks378 on Mar 31, 2014 20:34:48 GMT -5
I am in the process of replacing my chain plates. Does anyone know if the upper and lower shroud chain plates are the same length and bolt pattern?
Thanks,
Michael
|
|
|
|
Post by roverhi on Apr 3, 2014 14:24:40 GMT -5
Replaced mine with 1/4" SS flat stock. Took 1 each of upper and lower shroud to a machinist and he measured them in preparation for drilling the new, both were the same. The new ones went back in without a hitch. Cut the tops off the old plates and used them for backing plates. IIRC, the forward lowers are slightly bent to line up with the shroud. I did that after installation with a large crescent wrench.
|
|
