|
Post by svlily on Sept 20, 2015 21:35:00 GMT -5
I'd appreciate any photos or descriptions of good places to install thru-hull transducers, bilge drains, and also head/sink/shower inlets and drain thruhulls including a holding tank pump-out fitting.
Naturally I want to avoid or minimize te problems such as the sink inlet being aft of the shower drainhole, etc and causing disturbances for the transducers
|
|
|
Post by roverhi on Sept 21, 2015 17:29:18 GMT -5
Speed transducer is in the sump where the C/B axle is located on the port side. Think the depth transducer is in the bilge access hatch in the passageway by the head on the stbd. side. Both work fine under sail or powering. The Head sink drain is at the water line in the head and the head discharge is lower down on the same side. The head intake is in the head passageway on the stbd. side.
|
|
|
Post by svlily on Sept 28, 2015 0:23:27 GMT -5
Thank you -- so you mean that your head sink drain hose is connected to the toilet drain hose?
|
|
|
Post by roverhi on Sept 28, 2015 16:34:54 GMT -5
Sink And toilet outlet are to port but separate. The sink outlet is in the boot top stripe at the waterline. I'm 2000 miles away from boat at the moment so can't look to see exactly where the head outlet is. It may be in the cabinet just forward of the head/fore peak bulkhead and below the water line. .
|
|
|
Post by svlily on Sept 28, 2015 17:06:25 GMT -5
Sink And toilet outlet are to port but separate. The sink outlet is in the boot top stripe at the waterline. I wonder, I have a drain for the sink, a drain for the shower, and a drain for the onboard holding tank pump, plus the regular pump out drain. I'd like to minimize hols in the hull even above water. It would be great to combine a few of theses drains.
|
|